NC Filtration™ HEPA Filter (3rd Stage), 16"x16"x6"

HEPA Filter 16”x16”x6” are standardized using 5/8″ particle board framing.  Each frame is glued and stapled to provide a rigid enclosure for the media pack. Use with The Aeroclean™ 600 Mag by Aerospace America .  These filters are manufactured in the United States using American made materials.

Features

• 99.97% Efficiency
• Corrugated aluminum media separators
• Standard (18 pleats/ft.)
• Particle board frame
• Sealed internally with Urethane Sealant

Construction

Media:  Each filter is constructed from one continuous sheet of high strength waterproof glass microfiber paper, sealed to the frame on all four edges.

Separators: Media separators are corrugated aluminum.  A separator is placed between each pleat of media to prevent the pleats from touching.  This allows the air to pass through with minimum of resistance.

Adhesive Sealants:  Standard sealants utilized are fire retardant rubber bade adhesive and urethane sealant.  These sealants are applied as a fluid and solidifies to provide a positive seal between the media pack and frame.

Gaskets:  All standard HEPA filters are equipped with a closed cell neoprene gasket.  Placement is on the Downstream side of the filter unless otherwise specified.

Pressure Drop Table:  99.97% DOP-HEPA Filters Initial Pressure Drop 1.00″ w.g.

These filters are manufactured in the United States using American made materials.