Fiberlock Fiberset PM is a pre-mixed, lockdown sealing treatment for microscopic residual fibers present after the removal of Asbestos Containing Material (ACM). Fiberset PM is a water-based coating that employs advanced, 100% acrylic resin technology to extend the life expectancy of airless spray equipment.
- UL classified
- Class A fire rated
- Ideal for use as a pull-down
- Compatible with many flooring adhesives
Carefully clean up with a wet mop or HEPA vacuum.
Warning! If you scrape, sand, or remove old paint from any surface, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Carefully clean up with a wet mop or HEPA vacuum. Before you start, find out how to protect yourself and your family by contacting the U.S. EPA/Lead Information Hotline at 1-800- 424-LEAD (5323) or log on to www.epa.gov/lead
Apply Fiberset PM with airless spray equipment.
Use the settings below when applying Fiberset PM:
Pressure: 1700-3000 P.S.I.
Stir Fiberset PM thoroughly to achieve a uniform consistency. Fiberset PM is premixed; water-addition is not necessary. Minimum application temperature: 45°F.
Lockdown: Sealing microscopic residual fibers after asbestos removal is mandatory on every project. Prior to post-removal air monitoring, apply one coat to all exposed surfaces. Fiberset PM has been accepted as part of a UL Classified Fireproofing System for use with Retro-Guard® manufactured by W.R. Grace & Co., Conn. Coverage should not be less than 500 sq. ft. per gallon on smooth surfaces.
Pull Down by Misting: Misting the contaminated air is an effective technique prior to post-removal air monitoring. To pull down free-floating asbestos fibers effectively, stand in the center of the room and hold the spray gun as close to the ceiling as possible. A mist should be sprayed parallel to the ceiling in every direction or in a circle. Apply one coat to the polyethylene sheeting on the walls and floor prior to dismantling containment.
Lockdown: Not less than 500 sq. ft. per gallon.
Smooth Surfaces >500 sq ft/gallon
Porous Surfaces 350-500 sq ft/gallon
Drying Times: @ 70°F 50% R.H (Minimum application temp 45°F)
To Touch = 1-2 hours
To Recoat = 1-2 hours
Tools and drippings should be cleaned with warm soapy water before coating dries. Follow equipment manufacturer’s directions to clean spray equipment. Dispose of all waste according to current local, state and federal regulations.
Store in a dry place at temperatures between 40°F (4.5°C) and 90°F (32°C). Approved respirators must be used to prevent inhalation of asbestos fibers that may be present in the air. Protective clothing should be worn. Careful consideration must be given to all EPA, OSHA, federal, state and local regulations in effect prior to the application of this product.
KEEP OUT OF REACH OF CHILDREN.
Do not take internally. Close container after each use.
Keep from freezing
Store between 40°F (4.5°C) and 90°F (32°C)
24 hour Emergency “CHEM-TEL” - 800.255.3924